Gladiator GARS774SZG Installationsanleitung PDF herunterladen (Seite 5)

ASSEMBLY INSTRUCTIONS

Shelving Use Requirements

■ Intended for use in a garage.

■ Maximum weight limit is 2,000 lbs (907 kg) for each shelf, not to

exceed 8,000 lbs (3,628 kg) for the entire shelving unit.

Unpack

NOTE: Use two or more people to move and assemble shelving.

1. Remove and verify the contents. See “Parts.”

2. Dispose of/recycle all packaging materials.

Assemble End Frames/Support Beams

■ No tools required.

IMPORTANT:

■ Use two or more people to move and assemble shelving.

■ Determine shelf spacing before assembly.

NOTE: It is recommended to equally space the shelves from top

to bottom of the shelving unit. See “End Frames/Support

Beams” illustration.

Attach Shelf Support Beams to Welded End Frames

1. Position the 2 welded end frames (P4) vertical with the foot end

of each frame at ground level and profile slots facing forward.

2. At the desired shelf location, align both of the support beam (P2)

end tabs with the inside triangular frame slots on the welded

frame (P4).

3. Press the beam tabs down to the bottom of the frame slot (2 tabs

for each end of the support beam). This will lock the support

beam (P2) to the end frame (P4).

NOTE: If the support beam (P2) end tabs become bent, adjust

the tabs back to their original shape.

4. Repeat for other end of the support beam (P2). Check that the

height is the same for both ends of the support beam and for the

front and back support beams of each shelf.

5. Repeat steps 1 through 4 for each support beam for all 4 shelf

locations.

NOTES:

■ Front and back beams need to be at the same height, or the

shelves will not assemble correctly.

■ It may be necessary to adjust the end clip tabs back to their

proper form if they have been mishandled.

Support Beam Orientation

End Frames/Support Beams

Assemble Tie Channel Supports

This shelving unit is equipped with 3 tie channel supports (P3) for

each shelf.

NOTES:

■ The tie channel supports (P3) provide load support and structural

integrity.

■ All tie channel supports (P3) must be assembled as shown in “Tie

Channel Support Assembly” illustration.

1. Rotate the tie channel support (P3) into the front and back

support beam (P2), aligning the tie channel rivet heads with the

matching large diameter hole of the support beam keyhole.

2. To insert the rivet head on the other side of the tie channel

support (P3), apply pressure to both sides of the tie channel

support (P3), squeezing the sides toward each other. Insert the

rivet head into the matching larger hole of the support beam

keyhole on the front and back support beam (P2). Release

pressure.

WARNING

Excessive Weight Hazard

Use two or more people to move and assemble

shelving.

Failure to do so can result in back or other injury.

WARNING

Excessive Weight Hazard

Use two or more people to move and assemble

shelving.

Failure to do so can result in back or other injury.

P2—Support beams (8)

P4—Welded end frames (2)

1 2 3 4 5 6 7 8 9 10 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Gladiator GARS774SZG Installationsanleitung Seite 5

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für TV Ständer Gladiator GARS774SZG